Subscribe to our RSS Feeds

Automatic Emergency Torch

1 Comments »


Operation:

In the power supply section, capacitors C1 and C2 function as non-dissipating, reactive impedance which limit the current to a safe value. With the values of capacitors as shown, the maximum current that can be drawn is limited to about 70 mA at 230V AC. Resistor R2 limits the initial surge current and resistor R1 assists in discharging the capacitors after switch off. Diodes D1 through D4 form a conventional bridge rectifier while capacitor C3 is the filter capacitor. Fuse F1 is for protection and is very helpful in the event of any component giving up the ghost. This supply charges the battery as long as mains is present. In the 'switchover' section, transistor T1 is used as switch. Normally, when AC mains supply is present, the rectifier output charges the battery through resistor R4 and LED D4 combination at about 50mA rate. The glowing LED (D5) also gives an indication of mains presence. Further, due to the LED, base of transistor T1 is about 1.6V (drop across D5) more positive than its emitter. This voltage is more than sufficient to keep the transistor at cut-off. As soon as the mains voltage fails, the base of transistor T1 is pulled low through resistor R3 which drives transistor T1 to saturation thereby turning the bulb 'on'. Since the transistor is in its saturated state, the voltage drop across it is very low. Hence the bulb glows with full brilliance. The bulb can be switched off by the ON/OFF switch, when not required. With this bulb (2.2V, 250mA) the torch can work continuously for about two hours. The batteries should be charged for about 14 hours after they are discharged. Here is a word of caution now. Since the circuit is not isolated from AC mains, it may be hazardous to touch any component when the mains supply is on, especially if the supply wires (live and neutral) get interchanged. It is strongly recommended to use an all-plastic enclosure (including the reflector for the bulb) for the circuit. Also the on/off switch used should have a plastic lever. Take proper care and precautions while building, testing and using the circuit, and never ever allow the supply wires to interchange. It is advisable to provide a plug for the mains input on the box itself so that it can be plugged directly into a mains outlet. This reduces the chances of mains supply wires getting interchanged. With proper precautions and little care, it is hoped that this small circuit will help make life a bit more comfortable.

Features:

* Very reliable operation.
* As transformer is used, it is compact and cost-effective.
* The torch bulb glows automatically at power off and goes out on restoration of power.
* Since Ni-Cd battery is used, no maintenance is required. 


Circuit diagram: 




  



2:01 PM

1 Response to "Automatic Emergency Torch"

Anonymous Says :
April 18, 2015 at 7:53 PM

Hi there, I enjoy reading through your article post. I like to write a little comment to
support you.

my weblog kw2

Post a Comment

YOUR MESSAGE HERE...